I am having continuous problems with inconsistent results printing from my MacBook Pro (Sierra osx).
I’d say 1 out of 2 attempts, I get one of the below results, #1 being the far more frequent one:
1) A rectangle prints, and ends up in resin tank. I understand this is a result of the projector projecting on the computer screen & not in the printer
2) a print not attaching to the platform, and ending up as a silhouette in the resin tank
I follow the same recommended steps for setup every time, yet this still happens.
The other, new problem I started having is for taller objects (I am a jeweler, so we’re not talking very tall, we’re talking 1-1.5”) – the printer will print about half of it and that’s it. The other half ends up as silhouette in the resin tank. See the photos included, the shorter objects in the rear printed ok – but the ones you see in the front, which are rings, only printed half way. Their other half ends up in the resin tank, as a flattened silhouette.
Has anyone found a solution to these issues on a Mac?